Filling & Loading
   Turn raw material funnel up.
   Take out the canister by lifting the front side of it slightly.
   Open the lid and put raw materials into the canister.
   Close the lid after putting the raw materials into the canister.
   When putting raw materials, tilt the canister slightly backward for the materials not
      to get out of the front hole of the canister.
   Put the raw material canister in it's place.
Before assembling containers, make sure that the name of the material shown on
     the front is aligned with the canister contents
  Turn raw material funnel down.
Avoid any moisture from entering the canister as it will harden the coffee
Avoid tapping the canister as it will harden the coffee
   Lock the front door & enjoy a cup of Jarrah's Café Latte, for your effort.


     Routine Cleaning / Flush of Mixing Parts
   Press SETTING button [1] located in the door once .
   Press MODE button [2] 3 times. [you will see "CLE" on the display.
   Select the desired drink Button that you want to clean, [see front cover].
   If needed, repeat by selecting the desired drink Button you want to clean,
     [front cover].
   Repeat above for each of the drink lines.
   When finished Cleaning, Press SETTING button [1]. ["000"  will be displayed].
   Lock the front door & enjoy a Jarrah Choc O'Lait as your reward.


     Setting Coffee & Water Amounts
Preference is for this to be done by your Sapore Beverages Representative


     Setting Raw Material [Coffee] Volume
   Open the door of the machine.
   Press the SETTING Button [inside the door] once.
   Press the MODE Button once.
   Select the desired drink Button that you want to adjust. [from front panel].
   Adjust selected ingredient volume by pressing INCREASE or DECREASE Button.
Increasing the amount by more than 0.5 units from Sapore Beverages settings
     may cause blockages and or "blow outs" [very messy - try to avoid this]
   Press SETTING Button once again to restore machine to "operation mode".
   If in doubt - contact Sapore Beverages.


     Setting the Amount of Water
   Open the door of the machine.
   Press SETTING Button [inside the door] once.
   Press MODE Button once.
   Press the desired drink Button that you'd like to adjust twice [from front panel].
   Adjust selected ingredient volume by pressing INCREASE or DECREASE Button.
   Press SETTING Button once again to restore machine to "operation mode".
   If in doubt - contact Sapore Beverages.


Feedback or Referrals: admin@saporebeverages.com
 

                                        Home   Products   Our Machines   Benefits   Trial   Testimonials   Cost per Cup   FAQ's   Contact Us   Support   Order
                                     Copyright © Sapore Beverages